Описание

Extension Board for GT2-100P
Model GT2-E3P
Output PNP output
Mounting type Installed into GT2-100N/100P (up to 3 boards)
Main unit/Expansion unit -
Power supply voltage Supplied from the GT2-100N/100P
Power consumption Normal 4,200 mW max. (30 V, 140 mA max.)*1?
Power saving (Eco) 4,000 mW max. (30 V, 133.3 mA max.)
Display power Measured value display -
Other displays
Display range
Display resolution
Sampling rate 1,000 times/sec.
Control input Timing/preset/ reset/bank input No-voltage input
Control output HH/HI/GO/LO/LL PNP open collector, 30 V 50 mA or less*2, residual voltage 1 V or less
Response time hsp (3 ms), 5 ms, 10 ms, 100 ms, 500 ms, 1 s
Environmental resistance Ambient temperature -10 to +50 °C (No freezing)
Relative humidity 35 to 85 % RH (No condensation)
Vibration resistance 10 to 55 Hz, Double amplitude 1.5 mm, 2 hours in each of the X, Y, and Z directions
Materials Main body case: Polycarbonate, Key top: Polyacetal, Front sheet: PET
Power supply / I/O cable I/O: 30-pin connector (MIL standard)
Weight Approx. 80 g
*1 For GT2-100 Series, when the maximum number of sensor heads are connected and all units are set to power saving mode. *2 When 2 or more sensor heads are connected, 20 mA or less.
''